any help on issue will be appreciated
RonC
spinaudio roomverb 2 m2 - lowering cpu?
-
- KVRAF
- 6490 posts since 14 Jun, 2004 from Rochester, NY
Juuust wonderign if anyone knows any nice tips on how to lower cpu usage on roomverb? I must admit not much time to chk manual and toy with it, only have had time so far to just use the presets... when I checked out artsacoustic i was like hmmm!!! but it'd be hard to decide between the two unless I could figure out a solution- it seems a lot of cpu is used
any help on issue will be appreciated
RonC
any help on issue will be appreciated
RonC
-
- KVRist
- 262 posts since 8 Jun, 2005
I can only speak for the AAR, there you have a few options to lower the cpu load:
- set quality to low
- set bit dpeth to 32
- set density to lower values
Afaik, these are the parameters that directly affect CPU usage, but also sound quality, though.
Sorry that I can't help for the M2... (as I always prefered AAR to the M2
)
- set quality to low
- set bit dpeth to 32
- set density to lower values
Afaik, these are the parameters that directly affect CPU usage, but also sound quality, though.
Sorry that I can't help for the M2... (as I always prefered AAR to the M2
)