Elevayta 'Clone Boy' - New Discussion on Old Thread

[Space Boy]

Ok so now that I have DelBoy (Thanks SB) how do I use it to cancel out the TX on clone boy without killing the RX signal?

L

Place it after your Tx instance of Clone Boy and press "Mute". Like this:


Note: The version of Elevayta Clone Boy shown here is not yet released!

[Lagrange]

I was going to say grrrrraaaaaalll purdeeeeee...

Sorry for being a pain in the ass but alls the mute on DelBoy does is mute the TX's channel output .. I can still hear the TX audio on the RX channel (something told me it was going to do this).. What I want is to apply that stereo curve thing from the TX to the left and right channels of the RX without the TX's audio being played thru..

Heres a crude diag..



If you tell me that the Mute button on the full version does this then where on the same page..

Let me know. Thanks

L

[Space Boy]

The Mute button mutes the audio output from the Tx track. The Tx audio you hear on the Rx track is exactly what Clone Boy is supposed to do - like a vocoder.

Now, if you just want the stereo imaging from the Tx transfered to the Rx audio then Clone Boy is not the right tool.

I probably can make such a tool - but not this week.

My simple advice. Clone Boy is not what you want.

[Lagrange]

So basically version 2x does the same thing as the demo version? Ok I will bug you later on to see if you can put something together..

BTW what would I pay for something like this?

One great application for this plugin as is.. is to put a reverb on the Rx channel. It gives any reverb a tightened sound (as it is emulating the audio on the Tx).. Still a really good plugin for those that are reading these posts..

L