LiveLab.dk

GilJ · Post by **GilJ** » Sun May 27, 2007 2:54 pm

Thanks DarkStar

I agree with you: on my computer the waveforms' changes are very slight too, but what puzzled me was: as we are in the digital domain, there shouldn't be any changes at all in the waveforms when we record the same loop several times, should it?

May be that behind this "minor strange behavior", hides a more important refreshing GUI or synchronization issue? Who knows... may be Ohm?

Cheers,
GilJ.

ohm · Post by **ohm** » Wed May 30, 2007 12:21 pm

RC 4 is out

fixed all BR's exept the waveform one it's not serious. It has to do with how recording is timed - it's not always 100% sample accurate and even 1ms delay will cause the waveforms to be a little different. The drawing of waveforms is a bit crude, but since you can never argue that one graphical representation is more "accurate" than another, I'll leave them as they are.

DarkStar · Post by **DarkStar** » Thu May 31, 2007 4:39 pm

No problems here.

Fixed: BR 087 - A Reversed Event has some initial graphics glitch
Remains: BR 092 - waveforms remain in Slicer when loop is deleted

globalgoon · Post by **globalgoon** » Mon Jun 04, 2007 2:51 pm

i don't thnk i got an email for this version, the address i registered with was probably: mail@globalgoon.com

DarkStar · Post by **DarkStar** » Mon Jun 04, 2007 4:51 pm

v145 is at the Release Candidate stage.
The formal version has not been released yet, so emails have not been sent out.

Caleb · Post by **Caleb** » Tue Jun 05, 2007 12:56 am

Although we must be getting close - no rumblings from the excellent QA team.

Regards
Caleb

DarkStar · Post by **DarkStar** » Tue Jun 05, 2007 7:51 am

yeah - where's the missing rumble parameter? (so I can emulate my old LPs)

LiveLab.dk

KVR Audio

liveslice 1.45 beta thread