KVR Audio

sonoro_vienna · Post by **sonoro_vienna** » Sun Jul 22, 2007 5:20 pm

hey...

since today i have a serious problem with my ti. i was sitting in front of my pc starting cubase and then i tried to start the virus, but nothing happened except for a blinking display. i've tried to reset, didnt work, i have tried to plug off the power supplie and replug it but it just starts blinking again without me pressing the transpose button...sometimes it blinks one time per sec, sometimes faster.

did anyone else ever had this problem...

and btw. how long is the warranty for a ti

cheers

Signal chain · Post by **Signal chain** » Sun Jul 22, 2007 5:25 pm

umm I don't know ...
I usually sit in front of my pc, ... wake up the virus ... and then I start cubase ...
my two cents,
marco

sonoro_vienna · Post by **sonoro_vienna** » Sun Jul 22, 2007 5:29 pm

thx for telling me that you have no idea!

scoobz · Post by **scoobz** » Sun Jul 22, 2007 5:58 pm

at least signal was trying to help, I see you've already posted @virusti.com that was going to be my advice to you. They know they're stuff over there and there are various reset procedures you can do which will recitfy your problem

Good luck and keep us posted

Scoobz

Mikelo · Post by **Mikelo** » Mon Jul 23, 2007 4:50 am

mmm sounds strange, I've never experienced that with my TI keyboard.
When you say you have switched the power off.. have you left it off for more than 30 seconds? If not, try that first.
Also, have you touched the virus when updating firmware?
If you are really stuck, I suggest going to my favorite unoffical Access site, there are a couple of guys from the Access team, Ben and Marc. Im sure they will help you.
Its at:

http://www.virusti.com/forum/

Good luck !!!

Signal chain · Post by **Signal chain** » Mon Jul 23, 2007 8:12 am

I 've said it's the other way around ...
are you deft?

virusTI startup