Volume output
-
- KVRist
- 110 posts since 12 Feb, 2005 from Toledo Ohio living in OZ
Is there a way to increase the volume of the station? I have noticed that I have to turn up the volume when using station and then get blown out when I switch to any other synth. THe volume seems to be lower on the pianos and acoustic samples. SOme of the synths are louder but not like my others. I have gone to the config page and raised it as much as I could. Is there any other way?
-
- Mod-ulator
- 2895 posts since 31 Oct, 2000 from "Where I'm to, There I'll be"
Hi
On each individual layer of ManyStation is a volume control and also on the Master page there is a master volume control.
Try adjusting each of those that are active.
Some acoustic sounds will never be as loud as heavy synths etc. but we've never had an issue with not getting enough volume out of them, so mess around a bit there and I think you should be good.
Also perhaps some of your other synths may be too loud, there are plenty on the market that have much too high levels and clip out of the box.
Paul
On each individual layer of ManyStation is a volume control and also on the Master page there is a master volume control.
Try adjusting each of those that are active.
Some acoustic sounds will never be as loud as heavy synths etc. but we've never had an issue with not getting enough volume out of them, so mess around a bit there and I think you should be good.
Also perhaps some of your other synths may be too loud, there are plenty on the market that have much too high levels and clip out of the box.
Paul
