Edirol PCR-300 FL/Reason issue

[whorlock]

I'm trying to link controls with my PCR-300 to Poizone and Toxic in FL, which is fine, everything works except if I choose, say a cutoff filter in Poizone, and assign it to the R1 knob, I can't assign anything else to those R series knobs without over writing that message. And each R knob form 1-9 transmits the same signal to the same effect. I know that this is a PCR issue because in Reason when I try to use the controller at all, it keeps the note sustaining. It's not aftertouch or anything.

Anyone have the same issue? Can anyone help?

Thanks a bunch.

[wavex]

same here... any ideas? the readme says something about use with reason 1.x and 2.x... and not 3.x, any help?