KVR Audio

Architeuthis · Post by **Architeuthis** » Thu Mar 27, 2008 6:57 pm

Ah, don't worry about Large, his manners are small.

Here's my attempt

MP3: http://www.elanhickler.com/misc/woody_bass.mp3
Midi: http://www.elanhickler.com/misc/woody_bass.mid (95bpm)

Code: Select all

           Saw Wave
               |
    (Left)<---/ \--->(Right)
      |                 |
Formant Filter    Formant Filter
      |                 |
       \ ____     ____ /
              \ /
               |
       Stereo Bit Crusher
               |
      (Low and Hi EQ boost)
               |
              Out

Modulate the both Formant Filters slowly and separately.

Large · Post by **Large** » Fri Mar 28, 2008 1:35 pm

Not bad, but where's the preset?

Architeuthis · Post by **Architeuthis** » Fri Mar 28, 2008 3:08 pm

My signal chain is KarmaFX --> FilterBank3 --> ReaEQ

You would have to have these plugins for the presets to be useful. However, everyone has access to a saw wave, bitcrusher, and equalizer. I'm not sure if there are any good free formant filters though.

MaliceX · Post by **MaliceX** » Fri Mar 28, 2008 3:14 pm

Architeuthis wrote:My signal chain is KarmaFX --> FilterBank3 --> ReaEQ

You would have to have these plugins for the presets to be useful. However, everyone has access to a saw wave, bitcrusher, and equalizer. I'm not sure if there are any good free formant filters though.

The only 'free' effect I've seen that has a formant filter of some kind is AtlantisFilter.dll (comes with Atlantis)

Large · Post by **Large** » Fri Mar 28, 2008 3:31 pm

Can't you make a formant filter simply by layering multiple SVF bandpass filters at different cutoff frequencies?

(much the same way as you would make a Phaser)

himalaya · Post by **himalaya** » Fri Mar 28, 2008 7:57 pm

This sound doesn't require a formant filter, a band pass with individually selectable cut off points will do.

extremely WOODEN sounding baseline/ synthline