So, I've been working on a track for i dunno, 20 hours or so. I go up to pads 1-16 (the first set)
Last night I needed some more drums so I added some on pads 17-32. I used a total of 3 stereo outputs on the RMV, split around various pads etc.
So, everythings working dandy last night.
I open up cubase today and play back my tune and only pads 17-32 are outputting any sound. This makes no sense, all pads 1-16 are still loaded with the patches, they're just not outputting any sound. these share the same audio outputs are 17-32 as well so it makes no sense. even if I hit them manually they output nothing. Nothing is muted I will add.
Please is there a solution, this has taken me a long time and I dont get much music time.
If you tell me to update RMV, please tell me where the update is because it's VERY difficult to find on the linplug site, infact I don't know how anyone finds any updates for anything on there, unless I'm blind as a bat?
Also IF I update will I have to re-assign all the drums etc? i.e. write them all down before I re-install/update??
Thanks in advance!!!
RMV was my fave new thing until this, please make it my fave again !
