How to interpret the parameter amounts?

[Cyoon]

Hey,

i wonder how i shall interpret or translate the parameter amounts of Zebra in Mili Sec?

Like for example for the release of the amp Envelope..

On the top there is displayed the amount from 0 to ...

But how do i know what i exactly use in MiliSec.

this is very important for me to make sure always to have the right amount.

For example if i use a delay time calculator i always get ms amounts.

Would be very nice if it would be possible to switch the display to Milisec.

thanks,

Mark

[Urs]

The envelope parameters are scaled so that they allow for fine control on short values and coarse control on long values, hence they're not linearly mapped. It's thus difficult to say how many millisenconds any given value represents.

However, they tempo-synced modes (i.e. 4 quarters) are linear.

[Cyoon]

ok, hm..

could you gues it maybe?

Like how much is on half amoun how much on full..something like that?

thanks,

Mark

[pdxindy]

ok, hm..

could you gues it maybe?

Like how much is on half amoun how much on full..something like that?

thanks,

Mark

Read the manual... it does explain this stuff

[pdxindy]

Here is the manual page:

http://www.u-he.com/zebra/manual/?page_id=14