RMV and Synsoacc.dll

[mchoffmann]

Dear Linpluggers,
i installed latest version on Win XPSP3 and load into Samplitude. Every new start i get the message that synsoacc.dll can not be found in the system folder (which is true....). Is this some leftover from the old version using Syncrosoft Protection? And how do i get rid of it?


Liebe Grüße
Marc

[Branis]

I just removed the synsoacc.dll from my system32 folder to try to load RMV, and it started normally (I'm on Vista HP 32bit). Are you sure you installed the latest version (5.04)?

[mchoffmann]

It doesn't show up when loading, but when i save the project and reopen it the message appears.
I did clean up all old versions and installed RMV completely new.....
(Seufz..)

[Branis]

I don't know what can be the problem. It works fine here without the synsoacc.dll even after reloading a saved project. I tested in energyXT and MuLab.

[pwal]

can you re-set samp's plugin settings? (ie, it could be samp that's the prob, not rmv)

[mchoffmann]

can you re-set samp's plugin settings? (ie, it could be samp that's the prob, not rmv)

I dont think it's a Samp Prob. I rescanned the Plugins-Folder with no success and get the same result in Tracktion3.....

[standalone]

Dear Linpluggers,
i installed latest version on Win XPSP3 and load into Samplitude. Every new start i get the message that synsoacc.dll can not be found in the system folder (which is true....). Is this some leftover from the old version using Syncrosoft Protection? And how do i get rid of it?


Liebe Grüße
Marc

Maybe cleaning the registy would work , but I'm not suggesing that you do that without being completely sure . I think Syncrosoft will give you support about this .