RME Audio Interfaces

[jeswa]

Anyone know if they'll work?
I'm using the FireFace 400.

[os]

According to this:
http://www.rme-audio.de/forum/viewtopic.php?id=4551

the headphones output will work, but not the others.

[UCAudio]

The Fireface has 8 analog outputs... the headphone output is used for analog outs 7 and 8... it's an unbalanced TRS jack. Does that mean it could be used to send 2 different control voltages using Silent Way LFO? So one control voltage would be sent through output 7 (left headphone channel) and one would be sent through output 8 (right headphone channel)? Would any special cable be needed for this situation?

[os]

Does that mean it could be used to send 2 different control voltages using Silent Way LFO? So one control voltage would be sent through output 7 (left headphone channel) and one would be sent through output 8 (right headphone channel)?

Yes, that should work.

Would any special cable be needed for this situation?

You'd need a splitter cable - two mono (TS) jacks wired into a stereo (TRS) jack, one wired
T->T
S->S
and the other wired
T->R
S->S

This is a fairly standard cable for a splitting a stereo signal to two mono ones - it's also commonly used as an insert cable on a mono mixer channel.