RMV 5.0.5 beta (Mac and PC)

[graham]

Hi Graham,
thank you for the feedback. The beep is because of the missing startup kit and it's only in beta.

Regards the Battery kits not loading properly, is there a way to get access to a sample kit from those? We'll look at the amp envelope as well.

Thanks!

The only kits that are not greyed out when trying to load them are Battery 1 kits. None of the rest of the Battery kits can be loaded. THe Battery 1 kits do not allow anymore than a couple of pads to be played.

CPU spike of 25% still there when stopping play in Live (8.0.5 and previous versions).

Finally loaded factory content for RMV and beep on start up, as you suggested, is no longer there.

regards

Graham

[mabian]

I think I found a problem in 5.0.5 beta2, it was there in 5.0 and it was seemingly fixed, but actually not at all:

I clicked "Edit all" in a loop, then changed the out in a slice with right click: as expected, the out settings have changed for all the slices.

The problem is that also out settings for slices in other loops have changed (not in all loops, and when it happens it happens only in loops with smaller number than the one being edited).

I hope it is easily reproducible.

Thanks,
Mario

[mabian]

Anybody in da house?

- Mario

[Peter from LinPlug]

Thanks Mario,
I couldnt reproduce it but we will test it multiple times with all inhouse-versions we will do. Generally all Group Editing applies to all loops, a group is not bound to a certain loop, maybe that confused you (carefully asking ) ? Edit ALL just sets all slices of a certain (one!) loop to group X.

[mabian]

Thanks Peter,

I'll check it again to verify if I unintentionally added slices for different loops into the same group. But are you saying that Edit All adds slices to group X without emptying first the group?

Thanks,
Mario

[Peter from LinPlug]

right, count that as a feature or bug

[mabian]

Ok, so then how can I quickly empty group X? )

- Mario

[Peter from LinPlug]

When you want to deassign slices from a certain group you should switch the "display mode" to the group, e.g. "group 4", so you see immediately all slices which belong to a certain group and you can deassign them by clicking them.