Hello! I just set up a snapshot bank with seven patches in it. From what I understand, I should be able to send MIDI program changes to switch between the patches in the snapshot. My question is: how does one determine what bank number a particular snapshot bank is? I've got my PC3 set up right now to send no bank change command, only program change 0 or 1. When I switch between these two setups, the Receptor changes over to a Battery bank instead of staying on my snapshot, and loads either patch 0 or 1 in that Battery bank.
Confused,
Paul
Snapshot Bank Bank Numbers?
-
Kevin@MuseResearch Kevin@MuseResearch https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=200693
- MUSEician
- 188 posts since 11 Feb, 2009
Paul,
I'm not entirely sure what your end-goal is, but it sounds like you would benefit by disabling the 'bank select'. You do this in Receptor's setup view by selecting the alternative option to 'ignore bank select and target...' You'll notice once you enable this a button appears at the end. Click on this to make sure multis is selected in the list and your good to go!
For future reference msb/lsb values used in bank select are listed at the bottom of every 'file load' menu on Receptor screens.
- Kevin
I'm not entirely sure what your end-goal is, but it sounds like you would benefit by disabling the 'bank select'. You do this in Receptor's setup view by selecting the alternative option to 'ignore bank select and target...' You'll notice once you enable this a button appears at the end. Click on this to make sure multis is selected in the list and your good to go!
For future reference msb/lsb values used in bank select are listed at the bottom of every 'file load' menu on Receptor screens.
- Kevin