Albino3 Modulating Envelopes (as Destinations)

Locked New Topic
RELATED
PRODUCTS

Post

Hi guys,

Next Albino qn if I may :D

Is it possible to set EnvF1 and EnvAmp "send" levels as modulation destinations. At the moment the filter/pitch effect I have programmed is running continuosly, however I only want it to occur when I move the pitch/mod wheel.

The effect is predominately made via the EnvF1 and EnvAmp Envelopes so it occurs on every note (as you'd expect), but I cant see a way to assign the Envelopes as Mod Destinations. I have tried EnvF1 Attack but it isnt doing what I expected/need it to.

I have spent a few hours today headscratching about tricky convoluted ways to work it, but i'm officially out of ideas now.... :?

Help pls :D
"I was wondering if you'd like to try Magic Mushrooms"
"Oooh I dont know. Sounds a bit scary"
"It's not scary. You just lose a sense of who you are and all that sh!t"
Top

Post

I dont think its useful to change the modulation depth of the main amplitude envelope, otherwise you would never get back to 0 level when release finishes.
The filter envelope depth is adjustable with the filter env depth dial, just set this to 0 when you want to modulate it and manually route the Filter Envelope to the Filter, e.g.

Fil-1-Envelope 0.000 Fil-1-Cutoff

and use the mod wheel to control this, e.g

Modulation Wheel 0.500 Matrix Depth 1

assuming you laced the envelope to cutoff routin in matrix slot 1.
Top
Locked

Return to “LinPlug”