Muon Software

joeyfivecents · Post by **joeyfivecents** » Fri Feb 06, 2004 4:30 pm

sometimes when I open up the 303 in FLStudio, it won't let me adjust anything (res,Q,etc.) should I reinstall it? Has anyone else had this problem?

omicrom · Post by **omicrom** » Fri Feb 06, 2004 4:59 pm

I have also encountred this problem, but if you assign controllers to the knobs they work fine.

Muon Software Ltd · Post by **Muon Software Ltd** » Fri Feb 06, 2004 9:07 pm

Odd, not managed to reproduce this here. I'll look into it.

Regards
Dave

Shifrin · Post by **Shifrin** » Fri Feb 06, 2004 10:28 pm

Just to say,

I've had this happen in EnergyXT too, can't move any of the dials (but the switches work!). If I assign a slider in eXT to a dial and move the slider - the dial moves! Weird!

Shif.

2windy · Post by **2windy** » Wed Feb 25, 2004 9:06 pm

I get the same bug in Orion Platinum 5.2. No knobs move unless I assign them individually to slider on my Radium.

Muon Software Ltd · Post by **Muon Software Ltd** » Thu Feb 26, 2004 11:10 am

OK - now this one I can reproduce in Orion Pro (though all seems well in Fruity). Very odd, we'll look into it.

Regards
Dave

Muon Software Ltd · Post by **Muon Software Ltd** » Thu Feb 26, 2004 2:08 pm

It seems the CM303 that got released was built with a slightly older version of the GUI knob control code

I've now replaced the code with the right file and rebuilt it, all seems well now in EnergyXT and Orion. We'll release a PC version update shortly. Mac users are not affected as far as we know.

Regards
Dave

Muon Software

KVR Audio

cm303 bug?