Oh and one extremely important feature not to forget to add - A horn/tweeter bypass/defeat switch or a level control on the cab/cabs btw as distortion through a horn/tweeter is nasty ear bleed material and not in a good way as you will already know (akin to DI'ing a Boss MT-2 MetalZonejustin3am wrote:Well the pre-amps will be normalled with a buffer, so if you only connect input 1 it feeds input 2 without signal loss. Most of the signal processors I use are stereo though, and I'm just as likely to use the amp with a synth as a guitar.
So the amp will take a mono or stereo signal. Right now I just have a single channel of the preamp. I'd like to make it so you can use it as a traditional switchable two-channel mono amp or as a stereo non-switchable amp. The circuit that allows me to use a single set of controls for both amps in stereo mode, while using independent controls for each amp in mono mode, is kinds tricky though. I may end up using a pic or atmel processor to control everything digitally.
- Some black metal types might like it...) but just incase you have not added it to your spec list Justin my friend
YMMV of course and I do like an old school stereo guitar rig with a wet side and dry side, but would that sound good too widely spread?
)
