using cantabile as a host for effects

[Marc3]

hi,

my external hardware has two effect sends. i would like to process the signal from each effectsend by a VSTeffect in cantabile.

what i dont get is... how can i configure more than one audio inputs in cantabile? all i see is the audio input on off switch. but how can i choose from several audio inputs, each for a specific effect?

[TiUser]

First you should check your audio channels setup. Click there on inputs and you should see all available inputs.

Now you have to look into the master bus and configure that. That's a bit fiddly to be honest... look into the manual for details.

As far as I remember Cantabile Lite does not support master bus configuration - just in case you use that...