u-he

j0hnny · Post by **j0hnny** » Tue Sep 04, 2012 5:32 pm

Hello,

I installed the new version of Zebra...But one of my patches sounded slightly different. It contains a filter with an envelope and its depth assigned to a XY pad which is automated by Ableton Live.

I must also state that it was late at night, and I had consumed a few beers... But the filter envelope seemed less prominent on the new version. It sounded like it could have been rectified with some small adjustments, though I backed up to the previous version in the fear that all of my existing tracks could be affected.

Urs · Post by **Urs** » Wed Sep 05, 2012 3:37 am

send us the patch to support at u-he dot com and Fritz will check it out

The only differences should be added Modmappers, an XMF added to FX Grid and various niggles fixed.

j0hnny · Post by **j0hnny** » Wed Sep 05, 2012 8:53 am

Thanks,

I will make a direct comparison by loading both versions or bouncing down to audio... just to double check.

j0hnny · Post by **j0hnny** » Sun Oct 21, 2012 7:12 pm

Hello Urs,

I didn't get round to emailing Fritz. The arp was responding differently to incoming midi so I rolled back to the previous version.

Where Chords are input into Zebra in ableton live, each chord (which lasts one bar) has been duplicated on a midi track in blocks of midi clips in arrangement view. In order for the arp to play correctly, I have to create a gap (less than 1/128th or so) between the chords, so they are not played legato. So when the chords are played legato with no gaps, the arp doesn't run correctly.

Do you guys know what it could be?

Cheers

u-he

KVR Audio

Is Zebra 2.5.4 Different?