A few days later I receive the keyboard with great anticipation only to discover a dirt-like powder all in the bubble wrap they used which led me to notice all the gunk in the sliders! The powder was from the keyboard.. Ok so I picked up the keyboard and noticed there is a screw rolling around inside... not good. So I flip over the keyboard and notice non-standard screws in several places, some of which were only in about half way (and below the keyboard's feet -- could have scratched a surface)!! Some screws were completely missing. Very not good.
No power cable but I have a few around.. so no big deal there. I go to power it on.. the screen flickers briefly and nothing. uh-oh. I try a couple more times with slightly better results each time until it finally turns on.
All the keys worked.. some seemed a bit more spongey than others though.. not sure if that was a particular issue with that board or the model as a whole.
Then I notice it appears the inside of the slider tracks have what appears to be rust on them. The side panels are loose. And the kicker, the pitchbend wheel doesn't function at all!
Super bummed at this point (within an hour of receiving the keyboard through UPS) I drive to the 'local' GC (30 minute drive one way) and return it. The staffmember on hand hears my issues with it.. seems to act like they care and gives me a full refund and an apology. Ok then.
But then, a few days later now, I see they have listed it back on the used gear site!! THEY PUT THE FAULTY KEYBOARD BACK ON THE MARKET!
I suspect the transformer or the LED panel are on it's last leg.. the pitchbend wheel wasn't working either.. not to mention all the missing and non-standard screws that weren't even fully installed into the chassis. Unless they fixed this in a few days time (note this was a 12-15 year old keyboard - long discontinued) then it appears they are selling a product with many faults... and not listing a single one on their website.
Oh, and no I doubt it was due to shipping.. that is the one thing they seemed to do super well.. package and ship the board. It was wrapped in around 3 layers of large bubblewrap then surrounded in tons of packing peanuts. I did mention this in a long message to the employee who said it was in good working condition and they apologized profusely ok.. I hope they take more time in noticing these things.. I don't see how they missed a pitch bend wheel not working.. or the screw rolling around in the case.. or the screws not even fully inserted into the keyboard.
In any case, moral of the story is to be careful out there with your time and money when it comes to buying used products.. especially, it at least appears in this case, with GC used gear.


