CREAM - Accent (Velocity) to zero range? Or workaround?

[drewspuppet]

CREAM--

I am trying to setup an external potentiometer controller to work like an analog sequencer.

I have mapped a controller to have 16 knobs to control transpose and 16 knobs to control velocity somehow. The accent unfortunately does not go down to 'zero' as far as I could see... so it is not possible that way to set step to silent using this method.

I have tried using the CC stepper and then map to synth.. but many synths won't map cc's to velocity, only to volume or something which isn't the same with normal velocity modulations in program, etc.

Is there any way to get accent range down to zero or some other way to get velocity sent out?

Or for that matter is there a way to map a knob or button to a direct toggle on/off of step play? All I could figure for that was in the Order sequencer page where you would have to toggle between all different values.

[Kirnu]

I did a quick test and when setting the accent value to -100 the output MIDI note velocity is 0.
Isn't this working for you?

-Arto