D2 note won't make a sound in analog lab,

[michael2]

got analog lab installed and is working well with one problem: whenever I hit the note D2 on my keyboard: it's dead, no sound. it's not my keyboard as it works great with other synths; I have tried pencilling in that note into the piano roll and same thing: no sound. I am assuming that it is a MIDI cc thing, but damned if i can figure it out. thanks.

[corben]

Which version of Analog Lab are you running (launch AL, click on the Pref tab)?
Does this issue occur in standalone mode / in your DAW / both of them?

[michael2]

Which version of Analog Lab are you running (launch AL, click on the Pref tab)?
Does this issue occur in standalone mode / in your DAW / both of them?

thanks for piping in, much appreciated. I am running the latest version 1.1.0 and I have been having the problem in Logic 9. interestingly enough, I just tried to open it in standalone mode to see if it was happening there, and it won't open at all. i just keep getting an "application not responding" message.

EDIT: i just checked it in ableton and it was working fine. tried garageband and worked fine there. opened up logic again with a new instance of analog lab: worked fine. so weird. tried that last night about 20 times. this software is seriously buggy, but it sounds great so guess i'll stick it out.

[corben]

Hi michael2,

Sorry for this late reply.

Ok, do not hesitate to send an email to the Arturia technical support.