KVR Audio

Karbon L. Forms · Post by **Karbon L. Forms** » Sun Jun 27, 2004 4:21 pm

Every time I reboot my M-Audio Oxygen8 gets found as new hardware and a rather irritating install process ensues.

Any ideas?

dj_advent · Post by **dj_advent** » Wed Jun 30, 2004 11:48 pm

Hey, ya it was doing the same thing to me, but if you read the installation instructions, you have to run the set-up with the oxygen 8 usb plug disconnected. That's what your running into. Next time it requests a reinstall take out the USB cord from the back and go through the reinstall steps one last time and viola!!

smart · Post by **smart** » Wed Jun 30, 2004 11:57 pm

get the latest drivers from m-audio.com and then reinstall it following the directions that come with the drivers and you wont have any problems

I think just about everyone who bought one of these ran into the same thing

Sicklecell666 · Post by **Sicklecell666** » Thu Jul 01, 2004 12:10 am

the problem is that there's two seperate driver installations, & you probably cancelled out after the first one was finished. Let it run again after the first one is done & it'll install the rest of what you need.

I had to call tech support to get that striaghtened out for the Radium.

dj_advent · Post by **dj_advent** » Thu Jul 01, 2004 2:54 am

hahaha, I bet their tech support get's that call alot!!!

Karbon L. Forms · Post by **Karbon L. Forms** » Thu Jul 01, 2004 8:53 am

Ah! Instructions.

I usually read them as well. Thanks

Oxygen8 keeps re-installing