KVR Audio

vk122 · Post by **vk122** » Mon Jul 05, 2004 6:36 am

Please, can anyone give me some clue on how to record MIDI part generated by Groove Agent in FL Studio?
It seems that FL does not record MIDI output from a VSTi, at least Groove Agent is not recognized in MIDI Settings dialog. Changing OUT/IN MIDI channels in the Wrapper did not help.
At the same time, the MIDI OUT function in FL Wrapper suggests there are ways to channel VSTi output somehow...
A recording of GA part shows in Playlist but plays back quite another sequence with totally different pattern changes. The Piano Roll remains empty whatsoever.
Please, help.
Thank you.
VK122

peteralston · Post by **peteralston** » Mon Jul 05, 2004 7:59 am

probably best to go here - ga.clubcubase.net

what you must have recorded was some sort of automation data, it does get a little confusing about what to set as midi out , and in etc, but if you are using the demo, as mentioned in another post, I don't think you can record the midi out anyway.

Peter

vk122 · Post by **vk122** » Mon Jul 05, 2004 12:05 pm

Thanks for the reply, Peter.
Nope, both FLStudio and the Groove Agent are registered products.
Still the question remains open. Maybe version upgrade is a sensible move. I currently use FLS 4.1.2.
Thanks again.

Brother Greenmoon · Post by **Brother Greenmoon** » Mon Jul 05, 2004 12:40 pm

Have a look at the "Groove Agent Midi Dumping" thread on the Fruity Looptalk forum. It explains how to set up Midi Yoke to do what you want.

Stupid American Pig · Mon Jul 05, 2004 12:59 pm

vk122 wrote:Thanks for the reply, Peter.
Nope, both FLStudio and the Groove Agent are registered products.
Still the question remains open. Maybe version upgrade is a sensible move. I currently use FLS 4.1.2.
Thanks again.

There were some wrapper fixes in FL studio for 4.52, I would recommend getting to that version.

Groove Agent in FLStudio