(Reaper) Can I magify the envelope lane vertically to a specific range?

[JongHo]

(Reaper) Can I magify the envelope lane vertically to a specific range?

Hi. Normally, I try to set the initial volume of newly added instrument tracks to -12dB or -6dB, as many mixing guides suggests. So I could prevent the mixed volume to go beyond 0dB.

In this case, the point values of envelope will be from -12dB to -6dB or -3dB considering that I adjust the relative volume of each tracks. So when I adjuest the each point vertically, I only utilize the 1/2~1/3 vertical headroom of a envelope lane. So if I want to do more precise adjusting, I need to enlarge the envelope lane too big vertically.

Can I do a adjusting to a specific range vertically?

[Tricky-Loops]

The easiest solution is clicking at the envelope point, using the right-click menu of your mouse and entering the value manually...

Can I do a adjusting to a specific range vertically?

I'm quite sure that there should be an option either in the Project Settings or in the Preferences...

[JongHo]

Thank you Tricky-Loops.

Entering a numeric value is a good solution for a precise mixing. But I think that it is not good for visual aspect. It spares most of its headroom visually.



Is this the option that you mentioned?

[Tricky-Loops]

Is this the option that you mentioned?

Is there only the choice between +0 and +6 dB, can't you enter a value manually?

Would be a shame if nearly everything were customizable in REAPER but the automation envelope range weren't...