KVR Audio

samsam · Post by **samsam** » Sun Jul 05, 2015 8:09 am

maniacoli wrote:Pulse 2 v1.18 Firmware Update

Hi, there is a new Firmware Update for our beloved Pulse2

Cheers

elwood · Post by **elwood** » Fri Jul 17, 2015 10:17 am

Thanks for the heads-up regarding the update.

I wonder what is the status of the FX board that was being planned...? Will it ever become true?

Ingonator · Post by **Ingonator** » Fri Jul 17, 2015 3:43 pm

elwood wrote: I wonder what is the status of the FX board that was being planned...? Will it ever become true?

AFAIK this is still planned.

Ingonator · Post by **Ingonator** » Mon Jul 20, 2015 7:52 am

Due to the new OS update 1.18 I have updated the thread title and the change log in the OP.

Ingo

elwood · Post by **elwood** » Tue Jul 21, 2015 1:24 pm

Ingonator wrote:
elwood wrote: I wonder what is the status of the FX board that was being planned...? Will it ever become true?
AFAIK this is still planned.

OK, thanks for the info. I wish the FX parameters would be available as targets in the mod matrix.

Ingonator · Post by **Ingonator** » Tue Jul 21, 2015 2:14 pm

elwood wrote:
Ingonator wrote:
elwood wrote: I wonder what is the status of the FX board that was being planned...? Will it ever become true?
AFAIK this is still planned.
OK, thanks for the info. I wish the FX parameters would be available as targets in the mod matrix.

Does not seem to make sense to add targets before the FX unit actually exists. I am sure this could be added in an update during or after official release of the unit.

samsam · Post by **samsam** » Sun Aug 16, 2015 6:14 am

Just wanted to add to the thread a positive update story: just had the chance to play with the updated Pulse and Live - the arp now seems to sync fine which it wouldn't before. Thumbs up for the Waldorf devs making a great synth even more usable, for me at least.

D-Fusion · Post by **D-Fusion** » Sat Jan 09, 2016 10:34 am

Anyone else experience that hold function doesn't get released on next preset?
If a arp preset has hold enabled and you switch to the next preset it continues to play until you hit that note again.
I am using the latest firmware.

To test this go to preset no.008 and hit a note key and release it and it plays like it should because the hold is enabled in the arp setup.

While it plays go to preset no.009 and it continues to play.
So here it doesn't release the note at all but continues to play it on next preset.

If you browse back and forth a few times it eventually get released.
This is very annoying and should be fixed.

lalo · Post by **lalo** » Wed Jan 20, 2016 3:31 pm

any news on the 14bit MIDI CC front?

lentferj · Post by **lentferj** » Fri Mar 18, 2016 10:37 am

Firmware v1.20 is officially available from their website.

Waldorf Pulse 2: officially released (OS updated to v1.18)