Hi,
I'm trying to connect the ES-3 module to my saffire pro 40, all of the lights flash for the outputs however the ADAT does not light up the top LED.
Have tried to use the silent way controller to calibrate my make noise STO, but it does not react the way it should.
Any advice would be great
Dan
Big 'sync' LED does not come on when the ADAT cable is connected.
-
- KVRer
- 4 posts since 18 Nov, 2015
-
- KVRian
- 1417 posts since 22 Mar, 2002 from UK
Are you sure you're sending ADAT and not optical SPDIF?
-
- KVRer
- Topic Starter
- 4 posts since 18 Nov, 2015
I'm going from the optical output, which has a red light inside it.The cable I'm using is TOSlink optical cable which lights up when connected to the saffire.
Last edited by Dan Elkins on Wed Nov 18, 2015 9:06 pm, edited 1 time in total.
-
- KVRer
- Topic Starter
- 4 posts since 18 Nov, 2015
I have tried turning the modular off and on, now there are no lights flashing at all on the ES-3.
-
- KVRian
- 1417 posts since 22 Mar, 2002 from UK
The Pro 40's ADAT output can be switched into SPDIF mode. Please check you've not done that.
-
- KVRer
- Topic Starter
- 4 posts since 18 Nov, 2015
Hi Os,
Thanks for the quick reply. All is working perfectly, it was me being a dumb ass and not taking the protectors off the ADAT cable. I have never used this type of cable before
Thanks for making such an inspiring product.
Thanks for the quick reply. All is working perfectly, it was me being a dumb ass and not taking the protectors off the ADAT cable. I have never used this type of cable before
Thanks for making such an inspiring product.