KVR Audio

zammo · Post by **zammo** » Thu Jul 29, 2004 5:35 pm

hi..I have two monitors set up and working for the pc.. the thing is i use logic 5, and was wondering how u can split the screen to view the mixer on one and arrange on other etc.. cos at the moment they just view the same.. my card is a radeon 9600. thanks to anyone who can help...

DevonB · Post by **DevonB** » Thu Jul 29, 2004 5:38 pm

Set it for dual monitor in the Display Properties page.

Devon

zammo · Post by **zammo** » Thu Jul 29, 2004 5:55 pm

thanks for reply, but i have both working ,displaying the same.. i was wanting them to displaying as a single monitor spread onto two.. I cant seem to find it in the settings..

t-willy · Post by **t-willy** » Thu Jul 29, 2004 6:08 pm

http://www.ati.com/support/manualpdf/Rade9600.pdf

try page 13, this should do it.....i think you're going for the extended desktop mode

lates

t-willy

DevonB · Post by **DevonB** » Thu Jul 29, 2004 6:22 pm

There should be a checkbox for 'display across both monitors' or some such. I'm not at home to check.

Devon

zammo · Post by **zammo** » Thu Jul 29, 2004 6:33 pm

thanks .. it is the extended desktop mode i'm after but it doesnt seem to be there in settings .. i'm gonna try latest drivers..

zammo · Post by **zammo** » Thu Jul 29, 2004 8:01 pm

got there in the end! .. it seemed to be the 'ati control panel' when i uninstalled that, the 'extended desktop mode ' appeared again ...

Dual monitor setup