Hi,
I noticed a strange behavior with the automation datas in S1.
On the midi editor, if I hoover a controler lane, a line is added even if no automation datas are inserted.
This for every controler tab, so for example if I hoover the pitch bend lane, a pitch bend line is added.
What is the purpose of this behavior ?
It quicly becomes a mess because I can see the added automation lines inside the clip on the main window.
Studio one 3.2.1 automation
-
- Banned
- 1376 posts since 23 Jun, 2007 from france
-
- KVRian
- 1158 posts since 6 Jan, 2015 from London, England
The purpose? To make it easy to add automation lanes. If you don't want this behaviour, go to Studio One's Options, then Advanced, Automation, and uncheck the 'Automatically add envelopes for all touched parameters' option.
-
- Banned
- Topic Starter
- 1376 posts since 23 Jun, 2007 from france
Thanks but that option is already unchecked so it does not solve the issue.
-
- KVRAF
- 6159 posts since 4 Dec, 2004
A few of those (pitch bend and modulation included I think) are just default, I think they're always there once you go into the controller lane and they can't be removed, only edited.