Studio One - Impact>Ampire Issue

[zenophilix]

I like to use Ampire on my drum tracks to give it a bit of vinyl-esque crunch, but with my latest track it hasn't worked so well. The kick(s) work fine, but the snare(s) and hats don't seem to be affected. Am I missing something here?

[xcentric]

The kick may be mapped to it's own channel in the mixer. Same for snare, hats, and anything else. The channel each pad is routed to is right under the pad in Impact. It'll say 'Stereo 1', 'Stereo 2' (or Mono), etc. If thats the case then you have to put Ampire on each channel. That or you can route all the pads to the same channel in the mixer. Or you can keep seperate channels for each pad, and put Ampire on each channel. Another option is grouping the seperate channels to a bus and using Ampire only on the bus channel. Hope I didn't make matters worse by confusing you.

Here's a vid that may help better:

[zenophilix]

The kick may be mapped to it's own channel in the mixer. Same for snare, hats, and anything else. The channel each pad is routed to is right under the pad in Impact. It'll say 'Stereo 1', 'Stereo 2' (or Mono), etc. If thats the case then you have to put Ampire on each channel. That or you can route all the pads to the same channel in the mixer. Or you can keep seperate channels for each pad, and put Ampire on each channel. Another option is grouping the seperate channels to a bus and using Ampire only on the bus channel. Hope I didn't make matters worse by confusing you.

Here's a vid that may help better:

Ohhh. Can't believe I didn't think of that. I need to tighten up my effect workflow.