Hello!! I am trying to use two separate midi keyboards in Mulab but I just realized I might need a 3rd party to route my midi between channels. At this point what is available to me to make this happen? I remember using Midi Yoke eons ago and am not sure if this is still needed or working in my case.
Any suggestions welcome!
Thanks!!
Windows 10 midi routing help plz
-
- KVRian
- Topic Starter
- 1357 posts since 26 Sep, 2002 from Montreal, CANADA
Update : I have tried LoopBe and Loopmidi and have no clue if it is the right solution for me..it didn't seem to help. Midi Yoke is very old..not sure if this is the right solution.
Looking to your suggestions.
Looking to your suggestions.
-
worstcaseontario worstcaseontario https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=250833
- KVRer
- 11 posts since 19 Feb, 2011 from montreal
Yeah, a combination of LoopMIDI and MIDI-Ox gives me a pretty complete tool box for routing MIDI around my PC.
It used to be MIDI-Yoke and MIDI-Ox in the 32-bit environment. 32-bit MIDI-Ox works fine in 64-bit Windows if your virtual MIDI driver is 64-bit(LoopMIDI).
It used to be MIDI-Yoke and MIDI-Ox in the 32-bit environment. 32-bit MIDI-Ox works fine in 64-bit Windows if your virtual MIDI driver is 64-bit(LoopMIDI).
-
experimental.crow experimental.crow https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=6258
- KVRAF
- 6895 posts since 9 Mar, 2003 from the bridge of sighs
-
- KVRian
- Topic Starter
- 1357 posts since 26 Sep, 2002 from Montreal, CANADA
Thanks for your suggestions although I was suggested elsewhere that simply changing the midi channel on my controllers would work. I haven't tested it but will get back with my results later. Thanks