KVR Audio

Doug Nelson · Post by **Doug Nelson** » Wed Aug 18, 2004 8:27 pm

I know its not a very good approach, but I only own one microphone and I'm wanting to experiment with some voice effects in Cubase. It's a Labtec USB mono mic. My soundcard is an M-Audio Audiophile 2496.

Aside from that bit of information, I have no idea how to procede to get the mic output recorded in Cubase. Any suggestions?

C00kie · Post by **C00kie** » Thu Aug 19, 2004 2:35 pm

In CuBase you should select the LabTec Mic as the audio input device, not the Audiphile. Since I do not own one I can't tell you weather that will work, that is weather the Labtec's driver is selectable within CuBase.

Doug Nelson · Post by **Doug Nelson** » Thu Aug 19, 2004 4:16 pm

Thanks, but the Labtec doesn't show up in Cubase. I was hoping there was a setting somewhere to allow it to show up in the list.

USB mic into Cubase