TAL Software

mwaudioprod · Post by **mwaudioprod** » Fri Jan 20, 2017 3:11 am

It would be nice if the sampler had a stepless tune knob. Unfortunately, the tune knob snaps in halftones. This has the disadvantage that I can not make smooth pitch automations.

AnX · Post by **AnX** » Fri Jan 20, 2017 6:10 am

Does it do that when you use PB wheel?

mwaudioprod · Post by **mwaudioprod** » Fri Jan 20, 2017 2:28 pm

Yes, even then it snaps in halftones.

Maybe an option with shift and drag on the knob would be a good alternative to snap in halftones.

ere2learn · Post by **ere2learn** » Fri Jan 20, 2017 7:52 pm

Put a request in,they always listen to feature suggestions

https://tal-software.com/support/index

mwaudioprod · Post by **mwaudioprod** » Fri Jan 20, 2017 11:05 pm

The form is not for feature requests. I hope the developers see this thread.

ere2learn · Post by **ere2learn** » Fri Jan 20, 2017 11:08 pm

support[at]tal-software[dot]com

The dev doesn't visit this forum very often/at all

I have most of my past contact with him through twitter,so if your on it use that either

mwaudioprod · Post by **mwaudioprod** » Fri Jan 20, 2017 11:38 pm

Thanks!

TAL Software

KVR Audio

Tal Sampler stepless tune knob