ST2 Question

[Beardedone]

You can then easily swap out a snare for another

OK Right. Easy to say but how is this done? I still cannot figure out this aspect of ST2. I would like to swap some the snares out of one drum kit for some less strident snare hits. I would also like to tune the snares a bit lower since they always sound too high. Can anyone explain how to do that for just one note.

Thanks,
Gordon

[dgkenney]

I probably should keep my mouth shut because I am not at my music computer and can't verify if this is even possible, but here's my best guess. Couldn't you load both drumkits into the same channel (like a combi) and then use the Zone feature to mute the sounds you don't want from the appropriate kit(s)?

Again, just a guess.

Dan

[Beardedone]

Yes perhaps. Thoug I think I got an answer already in the companion thread here. Thanks for answering though.