KVR Audio

Sloe · Post by **Sloe** » Mon Feb 12, 2018 9:04 pm

I used to do this with clyphx for a live show - I wanted certain parameters of my delay and reverb on bus a and b to be automated, the only way to do this in Live 9 was with clyphx ( a scipt device helper thingy) Im talking about session view/Live mode here not linear sequencer mode, this is for a concert

So in a clip in a live set i could move a macro control knob on a midi track (or automate it within the clip) and that would send a message to a receiver knob in the fx bus - I could not do this without Clyphx.

It sounds great in theory but sometimes the knobs were slow to respond with Clyphx and in a live set it was problematic.

Can you now do this natively in Live 10? or do I need to go and get Clyphx again?

Has anyone else found another way to automate bus parameters by connecting them to clips? Is there anything in MaxforLive which does this?

Thanks for reading!

pottering · Post by **pottering** » Tue Feb 13, 2018 6:04 pm

Max For Live devices could control stuff in other tracks in 9.

You can send MIDI CC to other tracks, maybe you can use that instead of automation?

thecontrolcentre · Post by **thecontrolcentre** » Tue Feb 13, 2018 6:14 pm

Could you do it using dummy clips?

http://blog.dubspot.com/ableton-tutoria ... p-effects/

Sloe · Post by **Sloe** » Tue Feb 13, 2018 6:51 pm

someone recommended max for live Map8 device which Im going to look into, spunds like what i needed

Thanks for your input guys!

Kinh · Post by **Kinh** » Thu Feb 15, 2018 4:39 am

I cant find map8, is it 3rd party?

Trancit · Post by **Trancit** » Thu Feb 15, 2018 9:00 am

No, it comes with the included M4L packages

Kinh · Post by **Kinh** » Sun Mar 11, 2018 12:26 am

Still cant find map8. Seems no such device exists in m4l. There's multi map, is that what you meant?

pottering · Post by **pottering** » Sun Mar 11, 2018 1:23 am

It is in the Max for Live Essentials pack:

https://www.ableton.com/en/packs/max-live-essentials/

"MAP8: a utility macro device that's particularly useful with Push and other eight-knob controllers."

antic604 · Post by **antic604** » Sun Mar 11, 2018 9:15 am

pottering wrote:It is in the Max for Live Essentials pack:

https://www.ableton.com/en/packs/max-live-essentials/

"MAP8: a utility macro device that's particularly useful with Push and other eight-knob controllers."

Max for Live Essentials is not recommended to use for Live 10 (it even says it's for v9), because it contains devices that were updated for v10, like the LFO, Env. Follower, etc. Hope they'll update it properly for v10, because I in particular liked the synths.

Obviously, the devices work fine, just create a mess in your Browser, doubling some devices

Can you now automate FX on a bus from a clip in an Ableton Live set?