KVR Audio

Halonmusic · Post by **Halonmusic** » Tue May 29, 2018 11:57 pm

Im trying to figure out how to modulate parameters in a synth like filter cutoff and pitch etc. with snap heap in energyXT 3 but cant for the life of me figure it out. It is possible according to the manual, and i know this has to be done in the 'modular' window in energy xt but still cant figure it out. Any ext users who uses snap heap can help me out?

Per Salbark · Post by **Per Salbark** » Wed May 30, 2018 9:25 am

I haven't used energyXT but are you trying to automate the values from the DAW? Snap Heap only exposes the macro knobs to the DAW because of the temporary lifespan of the snapin parameters. That means you have to automate a macro knob and then set up an internal modulation from that knob to the snapin parameter you are trying to effect.

Halonmusic · Post by **Halonmusic** » Thu May 31, 2018 7:52 pm

Per Salbark wrote:I haven't used energyXT but are you trying to automate the values from the DAW? Snap Heap only exposes the macro knobs to the DAW because of the temporary lifespan of the snapin parameters. That means you have to automate a macro knob and then set up an internal modulation from that knob to the snapin parameter you are trying to effect.

Yes. I was trying to modulate the filter cutoff in a synth using the LFO in Snap Heap, aswell as using the ADSR envelope in Snap Heap (external mode) to modulate anything in Snap HeapSure i could just use an LFO in the synth but yeah.

Thanks for answering

Kilohearts Snap Heap external modulation ?