KVR Audio

4b11b4 · Post by **4b11b4** » Tue Jan 29, 2019 4:52 pm

If you turn your knurled nuts by hand... maybe I can save you some time.

Check out the video demo:

I want to share this tool!
If you're interested, send an email to:
eknutdriver @ gmail.com

Features:
- plastic: if you slip, it is less likely to scratch your faceplate
- torque: very easily torqued to proper tightness
- inexpensive: very little plastic material needed for 3D printed bit

whyterabbyt · Post by **whyterabbyt** » Tue Jan 29, 2019 4:56 pm

Ive always done them by hand, and dont build modules that frequently so it wouldnt save me a lot of time, but it'd be, erm, handy.

Is it an STL file you're talking about sharing?

You might be better off getting this moved to the DIY or hardware forum though, not sure.

4b11b4 · Post by **4b11b4** » Tue Jan 29, 2019 5:12 pm

Yep an STL file. I'd share it now but I'd rather do it properly with some documentation via my GitHub.
I'd also go ahead and make a model for a larger driver (the part that gets clamped into the drill - not sure what that is officially called).

I would also open source the openSCAD file so you could make your own if you needed to scale anything up.

I would also be interested in selling them if you don't want to deal with getting your own printed.

*yes maybe this should get moved to DIY. not sure about how to go about that.

Eurorack Knurled Nut - New Driver Tool