KVR Audio

BERFAB · Post by **BERFAB** » Thu Oct 31, 2019 12:42 pm

[If this is the wrong forum for this, please inform and I will move. Thanks]

I think Battery is one of the easiest samplers to work with. I load it up with all kinds of samples, not just drums. Each cell can be edited to taste fairly easily. However, for some reason, the included reverb defaults to the Master out, and I can't figure out how to apply the reverb to a single cell. Is there an easy "how to" or Youtube vid that might lay this out for me? I can't seem to find one.

Cheers
-B

chk071 · Post by **chk071** » Thu Oct 31, 2019 12:45 pm

I think it's only possible to use the reverb as a send effect for each cell?

BERFAB · Post by **BERFAB** » Thu Oct 31, 2019 12:57 pm

chk071 wrote: Thu Oct 31, 2019 12:45 pm I think it's only possible to use the reverb as a send effect for each cell?

So how to configure this, please?

AcrossTheSky · Post by **AcrossTheSky** » Thu Oct 31, 2019 1:08 pm

chk071 wrote: Thu Oct 31, 2019 12:45 pm I think it's only possible to use the reverb as a send effect for each cell?

in the manual page 88...use :

Buses Module

BATTERY provides a main effect / mix bus, and four additional effect/submix buses for processing
multiple cells at once before sending them to the main outputs (via the Master bus);
that way you can, e.g., send one group of percussive elements—let's say kick drums and
snares—through a compressor on Bus 1, and some hi-hats through Bus 2 with a high-pass filter
applied to create a submix within BATTERY.Additionally, you can also route any cell and/or effect/submix bus directly to one of the additional
direct outs, available via the cells'/buses' context menus (right-click/[Ctrl]-click). The
main output is by default routed to direct outs Stereo 1/2. Use the remaining direct outs to
bypass the Master bus, and to, e.g., address mixer channels in your host application directly.

have fun

chk071 · Post by **chk071** » Thu Oct 31, 2019 1:14 pm

BERFAB · Post by **BERFAB** » Thu Oct 31, 2019 1:21 pm

Oh, so you're saying there's a MANUAL?!

I will revisit this, thanks. I am aware of the buss module, but I couldn't seem to find a way to assign it from within the cell. [I have done this in the past, but can't remember how. Getting old, I guess.]

Cheers
-B

chk071 · Post by **chk071** » Thu Oct 31, 2019 1:31 pm

BERFAB wrote: Thu Oct 31, 2019 1:21 pm Oh, so you're saying there's a MANUAL?!

There is.

I actually quoted from it earlier, before i edited my post above, but, seems like i didn't quote the correct passage anyway...

How to put reverb in a single cell in Battery 4?