Goodhertz Can Opener Studio and Toneboosters Morphit/Isone

VST, AU, etc. plug-in Virtual Effects discussion
perpetual3
KVRian
1050 posts since 28 Sep, 2012

Post Sat Nov 16, 2019 5:33 pm

Can Opener and Morphit here.

ilmai
KVRist
422 posts since 25 Aug, 2016 from Helsinki, Finland

Re: Goodhertz Can Opener Studio and Toneboosters Morphit/Isone

Post Sun Nov 17, 2019 5:40 am

teilo wrote:
Sat Nov 16, 2019 5:22 pm
I use Reference and CanOpener in that order. It probably doesn't matter which order you have them when using Reference with a generic headphone profile as there is no difference between L and R correction curves, but if you have a custom profile from headphones you sent to Latvia, or purchased from them directly, then you definitely want Reference before CanOpener so that it flattens the L and R channels before CanOpener applies its crossover algorithm.
This is the official answer to plugin order from the FAQ:
What order should CanOpener be placed in the processing chain?

Ideally, CanOpener would be placed last in the processing chain on the master channel. If you’re not using CanOpener’s built-in dither, the processing order matters less, but CanOpener should still be near the end. If you are using a headphone EQ correction plugin that uses different profiles for the left & right channel, CanOpener should be placed in front of it.

vitocorleone123
KVRist
353 posts since 30 Jun, 2014 from Pacific NW

Re: Goodhertz Can Opener Studio and Toneboosters Morphit/Isone

Post Sun Nov 17, 2019 8:36 am

CanOpener --> Reference --> out

Return to “Effects”