KVR Audio

ubailey · Post by **ubailey** » Sat Dec 21, 2019 4:42 pm

I am using bitwig 3.1. Spent hours downloading a new channel strip from acoustics just to see bitwig not even show it, but other daws on the same pc can. Same issue with some other plugins as well. Anyone know how to fix this? Annoyed

Echoes in the Attic · Post by **Echoes in the Attic** » Sat Dec 21, 2019 5:26 pm

How long did you wait after opening it? Sometimes it takes a minute to show. Also try removing the dll and, opening again, then closing and putting it back, it will rescan.

antic604 · Post by **antic604** » Sun Dec 22, 2019 11:25 am

ubailey wrote: Sat Dec 21, 2019 4:42 pm I am using bitwig 3.1. Spent hours downloading a new channel strip from acoustics just to see bitwig not even show it, but other daws on the same pc can. Same issue with some other plugins as well. Anyone know how to fix this? Annoyed

Bitwig is actually the best with recognising VSTs because it's the only DAW of the 5 I have that detects them without having to exit and launch the DAW again and is least likely to blacklist them, from my experience (well over 200 plugins).

Make sure you have the right path (directory) set in the settings in Locations tab. Check the blaclist (the "Show plugin errors" button at the bottom of the Plugins tab). Also pay attention to a circle spinning in top-right corner - it means its indexing pluings, you have to wait until it's done.

Bitwig and VST’s