Hello,
I just worked with the new Melodya and i like it very mutch so fare, but i have one Question.Howe can i achive Melodys over more than one Octave ? This could be interesting fore Sololines. What is the Setup for that?
regards Keybert
Melodya Lines over more than one Octave
-
musicdevelopments musicdevelopments https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=223336 - KVRAF
- 6014 posts since 9 Jan, 2010
Hello Keybert,
thank you for your post! First you need to set up the "Note Range" in the Generation Options, I suppose you have done that.
The reason for the melody is quite limited in movement, is that only small leaps are allowed by default:
If you allow bigger jumps (Generation Options / Motive) the melody will be more interesting. Click on the presets, or you can set the weights manually:
or
You can decrease the probability of steps using the Steps/Leaps slider.
Please note that at the moment the first note always begins in the C4-C5 octave, on one of the allowed scale degrees.
Best regards,
Attila
thank you for your post! First you need to set up the "Note Range" in the Generation Options, I suppose you have done that.
The reason for the melody is quite limited in movement, is that only small leaps are allowed by default:
If you allow bigger jumps (Generation Options / Motive) the melody will be more interesting. Click on the presets, or you can set the weights manually:
or
You can decrease the probability of steps using the Steps/Leaps slider.
Please note that at the moment the first note always begins in the C4-C5 octave, on one of the allowed scale degrees.
Best regards,
Attila