Hi !
Hoping someone can help me solve this problem.
I'm using Soundcraft Signature 12 MTK (hw mixer) mixer, Cubase 8.5 on a Windows 10. That said - I'm not sure if this a MTK, Cubase or a 'Windows issue.
On my Cubase only channel 1 and 2 are active for in- and output.
And so, if I enable RTN (USB Return) on Chn 1 and 2 I'll get playback from the DAW.
However I'm not able to record to the DAW from any other channel on the mixer.
Actually, I am unable to record from any channel exept 1 and 2 from the mixer to the DAW. Despite if RTN is enabled or not.
Also - although I get playback from chn 1 and 2 there's no sound from the metronome.
Th3e driver is installed and all channels are showing up on Windows 10.
I've not found any guide / tutorial on how to setup Soundcraft Signature 12 MTK on Cubase. Have anyone seen any ?
Big thanks in advance for any help !
Soundcraft Signature 12 MTK setup on Cubase
-
- KVRian
- 1478 posts since 14 Jul, 2013 from Sweden
-
- KVRAF
- 2069 posts since 8 Feb, 2013 from Switzerland
Perhaps you need to do some routing in Cubase.
More info: Cubase 8.5 Manual page 21 - Setting Up the Input and Output Ports
More info: Cubase 8.5 Manual page 21 - Setting Up the Input and Output Ports
-
- KVRian
- Topic Starter
- 1478 posts since 14 Jul, 2013 from Sweden
Thanks !
In device settings only port 1 and 2, fro the relevant device, are shown as active (fro both in- and output).
Ports 3-14 are shown as inactive. How do I go about to activate those ports ?
No matter if I check / uncekc those ports they still shows up as inactive.
Any idea ?
In device settings only port 1 and 2, fro the relevant device, are shown as active (fro both in- and output).
Ports 3-14 are shown as inactive. How do I go about to activate those ports ?
No matter if I check / uncekc those ports they still shows up as inactive.
Any idea ?
-
- KVRAF
- 2069 posts since 8 Feb, 2013 from Switzerland
Video @ 0:53
-
- KVRian
- Topic Starter
- 1478 posts since 14 Jul, 2013 from Sweden
