If you’re looking for ‘boutique,’ then Night Owl Industries fits that bill. This company’s focus is on tone, while delivering something unique, and its current project is no exception – The Parabellum Drive (a collaboration with Dunwich Amps). It can hotrod a clean channel or make a dirty channel pop with pizzazz, as demonstrated in the video below. I would consider the Parabellum a low to medium gain drive, but when fully-cranked, the thick distortion does bring you into Sludge and Doom territory.
There are a number of aspects that make this drive unique. First, this is a 3-stage parallel EF86 tube-boost driven distortion. It does an amazing job at clearing up a tone (removes some mud), as the signal begins with a buffer, then splits into three signals, each going to a different germanium distortion: 1) traditional; 2) higher gain; and 3) a hybrid diode/germanium. These three distinct voices are processed individually then mixed back, thus producing a complex distortion that is jam-packed with harmonics, definition and detail that you would not get with conventional, in-series pedal builds.
Second, the active and passive EQ section is quite expansive, from tight lows to exceptional highs (it can transform the darkest and muddiest amps and pickups), with a midrange that “lay a perfect fourth in interval above and below the bass and treble controls, respectively.” Different pedals have EQ sections with a decent range, but the Parabellum’s is so broad that it compliments anything you throw at it.
Third, and this is the kicker, each control (Volume, Treble, Midrange, Bass and Gain) has its own GAIN switch (the mid boost switched was tuned by Dunwich Amplification, which also expanded the EQ section and modded the preamp for more gain). What you can do with this pedal is massive, and I tried to demo this various knob tweaking. But imagine dialing into a great EQ setting, but you wanted to boost the treble frequency, or perhaps the midrange or bass… or all three! In doing so, you do get a different result than merely setting the EQ on its own. And so, the Parabellum not only is a drive/distortion pedal, but it’s a treble booster… a midrange booster… and a bass booster. What I noticed is that the boost on each EQ emphasizes enough that if you like the treble at a certain frequency, it usually sounds better backing off a little and then engaging the boost (however, that’s how I like it). The boost on the Volume and Gain also produce unique results. The Volume boost pushes the amp harder, which results in more breaking up and a bigger robust sound – and this is true even if you turn the Volume knob all the way down, then engage the boost.
The Gain has a very diverse range. To hear anything through the pedal, the Gain knob needs to be turned up a touch, around 8-9 o’clock. The result is a fine grain distortion that puts a bit of hair on a clean channel and makes a dirty channel sing better with more detail. As you turn it up and nearing 12-noon, the tone is more intense, thicker and with some degree of saturation. Once past 12-noon, the saturation increases to the point of sounding like a distortion/fuzz combination (particularly full-bore). Now, if you happen to like the sound of the distortion around 10-o’clock, whereas dialing up more Gain results in too much saturation, then all you have to do is engage the Gain’s boost and you get that more intense rip-roaring tone. Further, turn down the Volume somewhat (or all the way) and flip on the Volume’s boost and the tone becomes more monstrous.
Overall, this is a serious pedal on so many levels, and if you need your tone to cut through the mix, the Parabellum does an exceptional job. I tried it with clean, dirty and hi-gain amps, and it sits perfectly well with the gear. I tried single-coil and humbuckers, with no issues and everything sounded great. In fact, it works well with a bass guitar, giving it a tighter bottom end and more punch – perfect for rock and metal. Two thumbs up!
Parabellum Drive (Review with Demo)
A forum for discussion of all things guitar!
Moderator: KVR Moderators (Main)
Parabellum Drive (Review with Demo)
2021-08-02T09:29:44+00:00
If you’re looking for ‘boutique,’ then Night Owl Industries fits that bill. This company’s focus is on tone, while delivering something unique, and its current project is no exception – The Parabellum Drive (a collaboration with Dunwich Amps). It can hotrod a clean channel or make a dirty channel pop with pizzazz, as demonstrated in the video below. I would consider the Parabellum a low to medium gain drive, but when fully-cranked, the thick distortion does bring you into Sludge and Doom territory.
There are a number of aspects that make this drive unique. First, this is a 3-stage parallel EF86 tube-boost driven distortion. It does an amazing job at clearing up a tone (removes some mud), as the signal begins with a buffer, then splits into three signals, each going to a different germanium distortion: 1) traditional; 2) higher gain; and 3) a hybrid diode/germanium. These three distinct voices are processed individually then mixed back, thus producing a complex distortion that is jam-packed with harmonics, definition and detail that you would not get with conventional, in-series pedal builds.
Second, the active and passive EQ section is quite expansive, from tight lows to exceptional highs (it can transform the darkest and muddiest amps and pickups), with a midrange that “lay a perfect fourth in interval above and below the bass and treble controls, respectively.” Different pedals have EQ sections with a decent range, but the Parabellum’s is so broad that it compliments anything you throw at it.
Third, and this is the kicker, each control (Volume, Treble, Midrange, Bass and Gain) has its own GAIN switch (the mid boost switched was tuned by Dunwich Amplification, which also expanded the EQ section and modded the preamp for more gain). What you can do with this pedal is massive, and I tried to demo this various knob tweaking. But imagine dialing into a great EQ setting, but you wanted to boost the treble frequency, or perhaps the midrange or bass… or all three! In doing so, you do get a different result than merely setting the EQ on its own. And so, the Parabellum not only is a drive/distortion pedal, but it’s a treble booster… a midrange booster… and a bass booster. What I noticed is that the boost on each EQ emphasizes enough that if you like the treble at a certain frequency, it usually sounds better backing off a little and then engaging the boost (however, that’s how I like it). The boost on the Volume and Gain also produce unique results. The Volume boost pushes the amp harder, which results in more breaking up and a bigger robust sound – and this is true even if you turn the Volume knob all the way down, then engage the boost.
The Gain has a very diverse range. To hear anything through the pedal, the Gain knob needs to be turned up a touch, around 8-9 o’clock. The result is a fine grain distortion that puts a bit of hair on a clean channel and makes a dirty channel sing better with more detail. As you turn it up and nearing 12-noon, the tone is more intense, thicker and with some degree of saturation. Once past 12-noon, the saturation increases to the point of sounding like a distortion/fuzz combination (particularly full-bore). Now, if you happen to like the sound of the distortion around 10-o’clock, whereas dialing up more Gain results in too much saturation, then all you have to do is engage the Gain’s boost and you get that more intense rip-roaring tone. Further, turn down the Volume somewhat (or all the way) and flip on the Volume’s boost and the tone becomes more monstrous.
Overall, this is a serious pedal on so many levels, and if you need your tone to cut through the mix, the Parabellum does an exceptional job. I tried it with clean, dirty and hi-gain amps, and it sits perfectly well with the gear. I tried single-coil and humbuckers, with no issues and everything sounded great. In fact, it works well with a bass guitar, giving it a tighter bottom end and more punch – perfect for rock and metal. Two thumbs up!
CoolGuitarGear
https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=478912
-
CoolGuitarGear CoolGuitarGear https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=478912
- KVRist
- 228 posts since 15 Nov, 2020
Post by CoolGuitarGear »
-
- KVRer
- 12 posts since 9 Aug, 2021
Post by altamijo92 »
Thanks for the review!
Post Reply
3 posts
• Page 1 of 1
Jump to
- The Main Forums
- ↳ KVR Studio Manager
- ↳ Getting Started (AKA What is the best...?)
- ↳ Instruments
- ↳ Effects
- ↳ Hosts & Applications (Sequencers, DAWs, Audio Editors, etc.)
- ↳ Guitars
- ↳ Mobile Apps and Hardware
- ↳ Soundware
- ↳ Samplers, Sampling & Sample Libraries
- ↳ Hardware (Instruments and Effects)
- ↳ Modular Synthesis
- ↳ Sound Design
- ↳ Production Techniques
- ↳ Music Theory
- ↳ Computer Setup and System Configuration
- ↳ DSP and Plugin Development
- ↳ DIY: Build it and they will come
- ↳ Music Cafe
- ↳ Sell & Buy (+Special Offers, Deals & Promos)
- ↳ KVR Experts
- ↳ KVR Developer Challenge 2023
- ↳ Everything Else (Music related)
- ↳ Off Topic
- ↳ Off Topic Classics
- ↳ Machine Learning and AI for Music Creation
- Official Company Forums
- ↳ 2getheraudio
- ↳ accSone
- ↳ Acon Digital
- ↳ AcousticsampleS
- ↳ AcousModules
- ↳ Agitated State
- ↳ AIR Music Technology
- ↳ AMG
- ↳ Ample Sound
- ↳ Antares Audio Technologies
- ↳ Apisonic Labs
- ↳ APU Software
- ↳ apulSoft
- ↳ AriesCode
- ↳ Arts Acoustic
- ↳ Arturia
- ↳ Audjoo
- ↳ AudioSpillage
- ↳ Audiority
- ↳ Best Service
- ↳ Big Tick
- ↳ Bitwig
- ↳ Controller Scripting
- ↳ Blue Cat Audio
- ↳ Cherry Audio
- ↳ CWITEC
- ↳ Embertone
- ↳ energyXT
- ↳ Eventide
- ↳ Expert Sleepers
- ↳ forward audio
- ↳ Future Audio Workshop
- ↳ FXpansion
- ↳ g200kg
- ↳ Harrison Mixbus
- ↳ HG Fortune
- ↳ Homegrown Sounds
- ↳ HoRNet Plugins
- ↳ Ilya Efimov Production
- ↳ Image Line
- ↳ Impact Soundworks
- ↳ Indiginus
- ↳ Insert Piz Here
- ↳ Ju-X
- ↳ Kirk Hunter Studios
- ↳ Kirnu
- ↳ Kong Audio
- ↳ Krotos
- ↳ Kuassa
- ↳ KV331 Audio
- ↳ LennarDigital
- ↳ Les Productions Zvon
- ↳ Liqube Audio
- ↳ Loomer
- ↳ LVC-Audio
- ↳ Maizesoft
- ↳ Manytone Music
- ↳ Media Overkill (MOK)
- ↳ MeldaProduction
- ↳ Mellowmuse
- ↳ MIDIMood
- ↳ moForte
- ↳ Mozaic Beats
- ↳ mucoder
- ↳ MusicDevelopments
- ↳ Tips & Tricks
- ↳ MusicLab
- ↳ MuTools
- ↳ New Sonic Arts
- ↳ NUSofting
- ↳ Oli Larkin Plugins
- ↳ Orange Tree Samples
- ↳ patchpool
- ↳ Photosounder
- ↳ PlugInGuru
- ↳ Polyverse Music
- ↳ Precisionsound
- ↳ Premier Sound Factory
- ↳ Psychic Modulation
- ↳ Realitone
- ↳ Resonance-Sound
- ↳ Reveal Sound
- ↳ Roger Linn Design
- ↳ rs-met
- ↳ S3A: Spatial Audio
- ↳ SaschArt
- ↳ Smart Electronix
- ↳ sonible
- ↳ SonicBirth
- ↳ Sonic Reality / eSoundz.com
- ↳ Soundiron
- ↳ SPC Plugins
- ↳ Sugar Bytes
- ↳ TAL Software
- ↳ Tokyo Dawn Labs
- ↳ Tracktion
- ↳ Tweakbench
- ↳ u-he
- ↳ u-he Linux support
- ↳ UJAM
- ↳ United Plugins
- ↳ VAZ Synths
- ↳ Virharmonic
- ↳ xoxos
- ↳ XSRDO - SynthCraft
- ↳ ZynAddSubFX
- Site Stuff
- ↳ Site Stuff
- Archived Forums
- ↳ AlgoMusic
- ↳ easytoolz
- ↳ Elevayta
- ↳ Hollow Sun
- ↳ LinPlug
- ↳ Muse Research and Development
- ↳ Shuriken
- ↳ SoHa Sound Design
- ↳ Soniccouture
- ↳ Topten Software
- ↳ Valhalla DSP
- ↳ CK Modules & VST
- ↳ Sennheiser AMBEO
- ↳ Muon Software
- ↳ Westgatesounds.net
- ↳ Squaredheads
- ↳ Sonigen
- ↳ CFA-Sound
- ↳ Back In Time Records
- ↳ Livelab.dk
- ↳ Skytopia
- ↳ audioD3CK
- ↳ Inspire Audio
- ↳ Krakli
- ↳ Drumdrops
- ↳ Futucraft
- ↳ OverTone DSP
- ↳ RaXnTraX
- ↳ solar3d-software
- ↳ Signaldust
- ↳ Soundemote
- ↳ ReleaseLab (Powered by Artist Expansion)
- ↳ Wolfgang Palm
- KVR Forum index
- All times are UTC
- Delete cookies