Hi,
Not sure if anyone has had problems with this but....
Since the Logic update I have noticed distortion in my tracks. I have checked several tracks dating back over a couple of years that I know were fine. Oddly the meters are within 0 db, and I tend to use softer limiting. I can't tell where it's overloading?
This is mainly using soft synths, Logic's stock and commercial plugsin by Arturia, u-he etc.
I have checked two different audio devices (my suspicion) but it's happening with both.
Any advice welcome as it's causing major hassle!
Logic Pro distortion after recent update 10.7.2?
-
Sound Mechanics Sound Mechanics https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=54454 - KVRAF
- 1663 posts since 10 Jan, 2005 from UK
-
Sound Mechanics Sound Mechanics https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=54454
- KVRAF
- Topic Starter
- 1663 posts since 10 Jan, 2005 from UK
Sorted!
Just in case others have this issue...
It was Loopback that I use to record standalone synths with OBS (video) for my website. It had created another input for Logic in the audioMIDI utility. This caused an overload, so I deleted it in Loopback and it deleted from the audio MIDI list.... so all's normal again.
Just in case others have this issue...
It was Loopback that I use to record standalone synths with OBS (video) for my website. It had created another input for Logic in the audioMIDI utility. This caused an overload, so I deleted it in Loopback and it deleted from the audio MIDI list.... so all's normal again.
