Looking for frontpanel design help

[AndreasD]

I need some help with those faders on the frontpanel

In M7 I created this:

Frontpanel M7.jpg

Those 3 frequency fader change in M8 to this:

Frontpanel M8.jpg

At least the leftmost on is how it looks now. The others, I started dabbling but with no solution.

I want a 'thin' fader with the "Freq" text on top and the numeric freq value at the bottom.
Because the freq value is quite wide, the faders need to be very wide to not be cut off. So I seperated fader and numeric value as two seperate items, which gives me the thin fader but now I have the dark frames in the way.

Any ideas anyone?

[runaudio]

Send me the file to my inbox please. i Will help

[runaudio]

i will make you a few knobs

[MuTools]

I understand that it may indeed be handy if you could define the width of the slider itself, so that small sliders are possible even with more wide text at the top/bottom. Taken note on the wishlist. (not for M9.0 though)

General note: Please note that special tricks with overlapping / overlaying components are not supported. It may work in some MuLab version but it's not guaranteed that it will look the same in future versions. Please make sure that front panel components are separate of each other.

[AndreasD]

Send me the file to my inbox please. i Will help

I appreciate your help!
Attached the MUX.

[runaudio]

Hey Thank you!