KVR Audio

HelgeG · Post by **HelgeG** » Thu Dec 16, 2004 1:17 pm

Is there any way I can suppress an incoming patch change mesagge in energyXT? (I am sending the MIDI signals from an external application to EXT, and among them are some patch change messages I would like to filter out)

C00kie · Post by **C00kie** » Thu Dec 16, 2004 1:48 pm

Maybe this can do: http://www.midiox.com/

midiox wrote:It can perform filtering and mapping of MIDI data streams.

HelgeG · Post by **HelgeG** » Thu Dec 16, 2004 1:53 pm

Thanks! I should have thought of it myself, as i am using MidiYoke by the same guys to route the MIDI stream in the first place

.

torhan · Post by **torhan** » Thu Dec 16, 2004 2:00 pm

Also --

Is the external midi device able to "not transmit" control change messages? Maybe you can shut it off at the source.

HelgeG · Post by **HelgeG** » Thu Dec 16, 2004 2:05 pm

torhan wrote:Maybe you can shut it off at the source.

I haven't found a way to do that. (The source is the trial version of Koan Pro, and so far I haven't found a way to turn off control messages there.)

C00kie · Post by **C00kie** » Thu Dec 16, 2004 2:50 pm

So what do parameters like Patch, Patch Change Bars and Patch Change Bars Range in Koan Pro actually do? Just curious...

HelgeG · Post by **HelgeG** » Thu Dec 16, 2004 9:21 pm

C00kie wrote:So what do parameters like Patch, Patch Change Bars and Patch Change Bars Range in Koan Pro actually do? Just curious...

Patch sets a patch, Patch Change Bars changes randomly between a predefined set of patches and Path Change Bars Range is the range over which the Patch Change Bars command is effective. So far I have not found a way NOT to set a patch for a given MIDI channel.

Suppress incoming MIDI patch change message