Program change messages in A360

[ukm]

I plan to use A360 with a Behringer FCB1010 Midi foot controller.
First I set up the programming software FCB1010Manager from Mountain Utilities and tested it with LoopMIDI and MIDIOX as MIDI monitor.
My presets are organized in a subfolder of the kuassa presets.
All works fine but I can't get A360 to react to program change messages (not only previous/next).
Any ideas appreciated.

Addition: I have the FCB1010 programmed with the editor now - works fine.
Though I can switch previous/next preset it seems there is no way to get direct access to a preset via program change. It would be nice if I could give a preset a progam change number (I think there are applications where this is implemented).