SSD vs HDD for storing libraries

[grg_98]

Hi guys!

Lately I've started to use samples libraries a lot more but I'm having some troubles loading huge staff into my projects.
Damage 2 for instance takes quite a long time to load, so I was wondering whether or not it's worth to buy an SSD to store these libraries.
Any thoughts?

Thanks

[BertKoor]

Since I couldn't be bothered to google it and write an answer, I asked ChatGpt and the answer is about what I expected:

ChatGPT
The data throughput, or transfer rate, of a storage device depends on various factors such as the specific model, interface type, and technology used. However, as of my knowledge cutoff in September 2021, I can provide you with some general information about the typical data throughput for hard disk drives (HDDs) and solid-state drives (SSDs).

Hard Disk Drives (HDDs):
HDDs consist of spinning disks or platters that store data magnetically. The data throughput of an HDD is influenced by factors like rotational speed, data density, and the interface used to connect the drive. Common interface types for HDDs include SATA (Serial ATA) and SAS (Serial Attached SCSI).

Typically, the data throughput for HDDs ranges from 80 to 200 megabytes per second (MB/s) for consumer-grade drives, with some high-performance models capable of achieving higher transfer rates. It's important to note that these figures represent average sustained transfer rates and not burst or peak rates.

Solid-State Drives (SSDs):
SSDs use flash memory to store data, providing faster access times and improved performance compared to HDDs. The data throughput of SSDs is influenced by factors such as the interface type, controller technology, and the specific NAND flash memory used.

SSDs connected via SATA interfaces typically offer data transfer rates ranging from 200 to 600 MB/s. However, SSDs that utilize faster interfaces such as NVMe (Non-Volatile Memory Express) can achieve significantly higher speeds. NVMe SSDs can offer sequential read and write speeds in the range of several hundred megabytes per second to several gigabytes per second, depending on the model and technology.

Please note that these figures are general estimates and may not reflect the latest advancements in HDD and SSD technologies. It's always recommended to refer to the specifications provided by the manufacturers for accurate and up-to-date information regarding the data throughput of specific HDD and SSD models.

So the answer is yes: replacing a HD by SSD is well worth the investment.

[jupiter8]

If you can get an NVMe SSD you'd wonder how you even bothered to breathe before. Best day of my life.

[legendCNCD]

SSD.

[grg_98]

Yeah It alreay made sense to me buy an SSD, just wanted to have some feedback. Thanks much

[FranklyFlawless]

Hi guys!

Lately I've started to use samples libraries a lot more but I'm having some troubles loading huge staff into my projects.
Damage 2 for instance takes quite a long time to load, so I was wondering whether or not it's worth to buy an SSD to store these libraries.
Any thoughts?

Thanks

Yes. For consumer-grade equipment, I suggest using NVMe SSDs, typically PCIe 3 or 4 depending on your motherboard. RAM can also be a factor depending on how much plugins and/or sample libraries you plan on loading/caching all at once.

[Beatbender]

SSD all the way. Significantly faster in reading and writing compared to HDD. + more energy efficient. Simply put, bang for your buck!

[thecontrolcentre]

SSD for sure ... faster, quieter, cheaper to run.
Plenty of RAM is a must too. ^^