Ozone Issue

[Scoops]

Looking for some help
I put this into Ozone Support over 2 weeks ago, and haven’t received a response

This analogy is true of the EQ in Ozone 9 and 10, and the Dynamic EQ in Ozone 9 and 10

I can put an EQ node in the spectrum view and adjust it to go outside of the boundaries of the spectrum view. I close the VST and go back into it later to adjust, but I can’t because the node is outside of the viewable area. (See Pic)

The user manual says: Equalizer Gain Scale: (dB) The filter gain scale is located on the right side of the spectrum view. Range: +15 dB to -30 dB.

But as you can see from the pic, the viewable db range is about ½ of what the manual says

Has anybody encountered this.
If you have, do you have a solution?

Thanks

[MattLeschuck]

Here are two quick solutions. Either switch to global mode to gain access to all the controls (this works for equalizer not dynamic eq), see pic 1.. Or hover over DB scale on the right side (see pic 2 and 3) and use your mouse wheel to increase the viewable DB scale. This will zoom the 15db boost in your case into view. You can see in pic 3 how the scale went to 0 - 6 - 10db etc. Where as in pic 2 it was in increments of 2 db. You can also click and grab that same area to move into focus.

1.png

2.png

3.png

[Scoops]

OK,

Many, many thanks for the response!!!

I knew about the Global View in the EQ, but this thumb wheel totally rocks!!!!!