KVR Audio

kroe · Post by **kroe** » Fri Dec 24, 2004 3:56 pm

I have an Edirol (audio card) but i can't set different audio tracks to different outputs, i just can route the tracks to the output 1...

How to config my Cubase to see the others outputs of my sound card???

Thanks a lot.

cptgone · Post by **cptgone** » Fri Dec 24, 2004 4:09 pm

Maybe you got some app to control the card with? Maybe it enables you to activate in/outs?

You can pick outputs in the Cubase Track Inspector.

The Bible explicitly forbids sodomy BTW.

kroe · Post by **kroe** » Fri Dec 24, 2004 5:14 pm

i think i just need to configure the Cubase...
'cause in Logic everything is OK...

kroe · Post by **kroe** » Tue Dec 28, 2004 8:23 pm

kroe wrote:i think i just need to configure the Cubase...
'cause in Logic everything is OK...

any sugestions?

rok · Post by **rok** » Tue Dec 28, 2004 8:32 pm

Did you try F4 and add bus

cold c · Post by **cold c** » Tue Dec 28, 2004 8:33 pm

Which version of Cubase?

You need more than one output bus. If you don't have more than one output bus you need to create/enable them (in both the ASIO control panel and in VST connections).

Then just route the track to the output bus.

All is detailed in the manual.

How to use different outputs with Cubase and Edirol??