KVR Audio

I haven't tried this but the normal CraveEQ is an exceptional tool. Highly recommended m/s EQ, sounds great.

I expect this transient version would also be very good.

pluginnow · Post by **pluginnow** » Fri Jan 19, 2024 10:21 pm

Havok wrote: Thu Jan 18, 2024 2:36 pm https://www.newfangledaudio.com/punctuate

Went try to demo it, but had problems with the Ilock thing.

pluginnow · Post by **pluginnow** » Fri Jan 19, 2024 10:26 pm

It's hard to find a good, accessible plugin.

To me, the main solution would be to be able to (graphical) draw the envelope for the whole mix.

Ah_Dziz · Post by **Ah_Dziz** » Fri Jan 19, 2024 11:17 pm

Voxengo had a spectral mix bus plugin that had transient shaping as part of it. It's been ages since I used it though. It also had dynamics and such.

Edit: it was soniformer

scott_free · Post by **scott_free** » Sat Jan 20, 2024 12:50 am

pluginnow wrote: Thu Jan 18, 2024 9:48 am It would work like a multi-band transient shaper, but with more bands for a clean, smooth effect.
Regards

Sounds like you might want to check out Oeksound Spiff. It can be very "clean" and "smooth" in its effect on the signal.

Funky40 · Post by **Funky40** » Sat Jan 20, 2024 6:53 am

scott_free wrote: Sat Jan 20, 2024 12:50 am Sounds like you might want to check out Oeksound Spiff. It can be very "clean" and "smooth" in its effect on the signal.

Do you know what latency it reports to the DAW ?
I´m into realtime uses

edit: just checking the demo. at 44khz its 4480 samples / 93ms.

the Hofa one finnaly runns now too. interesting. 20ms latency

martinjuenke · Post by **martinjuenke** » Sat Jan 20, 2024 7:40 am

pluginnow wrote: Fri Jan 19, 2024 10:21 pm
Havok wrote: Thu Jan 18, 2024 2:36 pm https://www.newfangledaudio.com/punctuate

Went try to demo it, but had problems with the Ilock thing.

Recheck your setup, this works normally flawlessly.

aagnello · Post by **aagnello** » Wed Mar 06, 2024 7:51 pm

SplitEQ has been described as a spectral transient shaper. Russell, lead dev, was recently on a podcast and explained why that's not the case.

The full SplitEQ discussion is here:

Spectral transient shaper ?